Radio Shack 2.4 GHz 2-Line Digital Spread Spectrum Cordless Phone with Call Waiting/Caller ID

On a Desk Top

1.Insert the bracket’s tabs into the base’s upper tab slots, then press down on the bracket’s clips and insert them into the clip slots.

2.To connect the phone to a two-line phone jack, plug one end of the supplied long two-line modular cord into the TEL LINE 1/2 jack on the back of the phone. Route the cord through the strain-relief slot on the bracket.

Note: If you connect the phone to a two- line phone jack with a two-line cord, do not connect a third line to the TEL LINE 2 jack or the phone will not operate prop- erly. Instead, you can connect another phone device, such as a fax machine or modem.

To connect the phone to two one-line phone jacks, plug one end of the sup- plied long two-line modular cord into TEL LINE 1/2 and plug another cord (not sup- plied) into the TEL LINE 2 jack. Route both cords through the strain-relief slot on the bracket.

To connect the phone to a single one- line phone jack, plug one end of the sup- plied long modular cord into the TEL LINE 1/2 or TEL LINE 2 jack. Route the cord through the strain-relief slot on the bracket.

3.Plug the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of

the base and route the adapter’s cord through the strain relief slot on the bot- tom of the bracket.

4.Plug the adapter into a standard AC out- let.

5.Connect the phone cord(s) to the modu- lar phone line jack(s).

6.Raise the base’s antenna to a vertical position.

On a Wall Plate or Wall

1.Insert the bracket’s tabs into the base’s lower tab slots, then press down on the bracket’s clips and insert them into the clip slots.

2.Connect the phone line(s) as described in “On a Desk Top”. Use the shorter modular cord to mount the phone on the wall plate.

3.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of the base.

4.Route the adapter’s cord through the narrow groove on the bracket. If you are using two phone cords, route the second cord through one of the wide grooves on the bracket.

5.Plug the other end of the short modular cord into the wall plate jack, then align the keyhole slots with the wall plate studs and slide the base downward to

Installation 11