Problem | Suggestion | |
|
| |
|
| |
The handset does not ring or receive a | Lift the base’s antenna to a vertical position. | |
page. |
| |
Move the handset closer to the base. | ||
| ||
|
| |
| Move the handset and base away from other electrical | |
| devices. | |
|
| |
| Set the ringer volume to either high or low. | |
|
| |
| Recharge the battery pack. | |
|
| |
| If the base loses power while the handset is off of it, the secu- | |
| rity | |
| the base, then place the handset back on the base and leave | |
| it there for a few seconds. | |
|
| |
| Check the number of devices connected to your phone line | |
| and add up the RENs. See “Read This Before Installation” on | |
| Page 2. | |
|
| |
You have an incoming call, but do not | Let the phone ring twice before you answer so the system has | |
receive any Caller ID information. | time to record the Caller ID information. | |
|
| |
| Check that the system is correctly and securely connected. | |
|
| |
| Call your phone company to verify that your Caller ID service | |
| is active. | |
|
|
If you still have problems, disconnect the phone. If other phones on the same line work proper- ly, the fault is in this phone or its installation. If you cannot find the problem, take your phone to your local RadioShack store for assistance.
CARE
Keep the phone dry; if it gets wet, wipe it dry immediately. Use and store the phone only in normal temperature environments. Handle the phone carefully; do not drop it. Keep the phone away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new.
Modifying or tampering with the phone’s in- ternal components can cause a malfunction and might invalidate its warranty and void your FCC authorization to operate it. If your phone is not performing as it should, take it to your local RadioShack store for assis- tance. If the trouble is affecting the telephone lines, the phone company can ask you to dis- connect your phone until you have resolved the problem.
Troubleshooting | 27 |
