![](/images/new-backgrounds/1309937/30993725x1.webp)
•If the handset’s display is blank and the phone does not work, recharge the bat- tery pack. (The battery power might be too low to light the display.)
•If the battery pack becomes weak during
a call, the handset beeps every 3 sec- onds and Bem 8Wjj[ho flashes. When this happens, you cannot make another call on the phone until you recharge the bat- tery pack.
•About once a month, fully discharge the
battery pack by keeping the handset off the base until Bem 8Wjj[ho flashes. Other- wise, the battery pack loses its ability to fully recharge.
•If the battery pack is completely dis- charged or the base loses power while the handset is away from it, place the handset on the base to reset the secu- rity
The supplied battery pack should last about one year. If the battery pack does not hold a charge for more than 2 hours after an over- night charge, replace it with a new
Note: To avoid losing memory numbers, in- stall and begin charging the new battery pack within 2 minutes.
Warning: Dispose of the old battery pack promptly and properly. Do not burn or bury it (see “Battery Safety Instructions” on Page 5 for additional information on proper battery handling).
If you have trouble replacing the battery, take the phone to your local RadioShack store for assistance.
Important: The EPA certified RBRC® Battery Recycling Seal on the
industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC program provides a convenient alternative to placing used
SETTING THE DIALING MODE
Your phone comes set for tone dialing. If you have pulse service, you need to change the dialing mode. If you are not sure which type of service you have, do this test.
Press LINE 1 on the base. The LINE 1 SPEAKER indicator lights. Listen for a dial tone, then press any number other than 0.
Note: If your phone system requires that you dial an access code (9, for example) before you dial an outside number, do not press the access code either.
If the dial tone stops, you have
To set the dial mode, press LINE 1 to hang up the phone if necessary, then hold down FLASH on the base until the phone beeps. Then press #/7 on the base to set to pulse mode or ∗/TONE/6 on the base to set to tone mode. The phone beeps.
Installation | 13 |