Radio Shack 4-Line Telephone System with Speakerphone and Caller ID Mounting The System

43-5709.fm Page 10 Wednesday, December 20, 2000 10:56 AM

Square Configuration

When all lines are all common, the configura- tion is called square. Since all lines are com- mon, calls on any line can be transferred to any station.

Non-Square Configuration/ Private Line Support

When all lines are not common, the configu- ration is called non-square. Depending on which line is connected to which station, you can transfer calls on some lines to some sta- tions.

The following chart shows a sample non- square configuration. In this configuration, lines 1 and 2 are common to all stations, and lines 3 and 4 are available to groups of sta- tions.

Stations 11, 16, and 17 have all the lines, so these stations can answer all lines. Calls to Lines 1 and 2 can be transferred to all sta- tions. Calls on Line 3 can be transferred to all stations except stations 14 and 15. Calls on Line 4 can only be transferred to the stations that have Line 4 (stations 11, 16, and 17 in the sample chart). If you want to build a non- square configuration, we suggest you make a planning chart similar to the sample chart for easier connection.

Note: You can also set private lines that are not included in the system. See “Setting Pri- vate Lines” on Page 20.

Station ID		Line Number
	1	2	3	4
Station 11	X	X	X	X
Station 12	X	X	X
Station 13	X	X	X
Station 14	X	X
Station 15	X	X

Station ID		Line Number
Station 16	X	X	X	X
Station 17	X	X	X	X
Station 18	X	X	X
Station 19	X	X	X
Station 20	X	X	X
Station 21	X	X	X
Station 22	X	X	X

Important: If you are using this phone as a sub-station to the SP708 phone system (Cat. No. 43-5708), and you have the Auto Atten- dant feature turned on, the Auto Attendant can answer all lines as well.

MOUNTING THE SYSTEM

You can place your phone on a flat surface, or mount it on a standard wall plate or direct- ly on a wall. Select a location that is near a modular telephone line jack and an AC out- let, and out of the way of normal activities.

On a Desk

1.Remove the mounting bracket by sliding it toward the narrow end of the bracket and lifting it off.

2.Plug one end of one of the supplied, long 2-line modular telephone line cords into LINE 1&2 on the bottom of the tele- phone.

3.Use a coin or screwdriver to fit the cord into one of the grooves next to the line jacks on the bottom of the phone. Then

10 Installation