Select the phone number to be stored from the Caller ID list by pressing RING/VOL/+ or
2.Press MEM.
3.Press RING/VOL/+ or RING/VOL/- or enter a number (0 - 9) to select the memory location to be stored.
4.Press SELECT. Ô
You hear a confirmation tone, and the number is stored in memory. The display returns to the Caller ID list.
ADDITIONAL
INFORMATION
INSTALLING THE BELTCLIP
To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.
HEADSET INSTALLATION
You can connect an optional headset with a 3/32- inch
To connect the headset, open the rubber cover on the side of the handset. Then insert the headset’s plug into the jack.Ô
When you finish using the headset, disconnect it from the handset and close the rubber cover to protect the jack.
Additional Information
Ô NOTES Ô
Storing Caller ID Messages in Memory Dialing
If a message has already been stored in the selected memory number location, a confirmation screen is displayed.
Press RING/VOL/+ to select ¨Yes¨. Press SELECT to overwrite. The display returns to the Caller ID list.
Headset Installation
•If you place the handset on the base to recharge it while the headset is connected, be sure the handset seats properly.
•You can use a handset holder (available from your local RadioShack store) to hang the handset on your belt for greater convenience when using a headset.
29
