If the scanner finds an active frequency, it stops and displays that channel and frequency number, then it automatically begins scanning again when the transmission on that frequency ends. ±

6WTPKPI"%JCPPGN/5VQTCIG" $CPMU"1HH"CPF"1P

Channel-storage banks (1-10) are on when they have a bar underneath them and off when no bar appears underneath them. To turn off a channel-storage bank, press the bank's number key during scanning. The bar under the bank's number disappears.

To turn on a channel-storage bank (1-10) during scanning, press the bank's number key. A bar appears under the bank's number. ±

You cannot turn off all banks. There must be at least one active bank.

You can manually select any channel in a bank, even if the bank is turned off.

When you turn on a bank during scanning, the scanner moves to the selected bank and scan it.

If no transmission is found, the scanner continues scanning to scan through all selected banks.

/QPKVQTKPI"C" 5VQTGF"%JCPPGN

You can continuously monitor a specific channel without scanning. This is useful if you hear an emergency transmission on a

±"016'"±"

Scanning the Stored Channels

To reverse the

scanning direction, press H or G.

To set the scanner to remain on the current channel for 2 seconds after the transmission ends, see “Delay” on Page 33.

To set the scanner to remain on the current channel, even after the transmission stops, press SCAN/MAN at any

time during the transmission. C7D appears and I97Dý disappears (see

“Monitoring a Stored Channel” on Page 29).

To lock out channels so the scanner does not stop for a transmission on those channels, see “Locking Out Channels or Frequencies” on Page 34.

Turning Channel-

Storage Banks Off

and On

The scanner does not scan any of the channels within the banks you have turned off.

Searching the One Touch Banks

29

Page 29
Image 29
Radio Shack PRO-82 manual Scanning the Stored Channels, Turning Channel Storage Banks Off