."%#76+10"."

Always connect the DC adapter to the scanner before you connect it to the power source. When you finish, disconnect the adapter from the power source before you disconnect it from the scanner.

Preparation

±"016'"±"

If you use a cigarette- lighter power cable and your vehicle's engine is running, you might hear electrical noise from the engine while scanning. This is normal.

7UKPI"8GJKENG"$CVVGT[" 2QYGT

You can power the scanner from a vehicle’s 12V power source (such as a cigarette-lighter socket) using a 9V, 300 mA DC adapter and a size C Adaptaplug™ adapter (neither supplied). Both are available at your local RadioShack store. .

To power the scanner using a DC adapter, attach the Adaptaplug to the DC adapter so the tip reads positive (+) and set the adapter's voltage switch to 9V. Next, insert the Adaptaplug into the scanner's PWR DC 9V jack. Plug the other end of the DC adapter into your vehicle's cigarette-lighter socket.

±

%QPPGEVKPI"VJG"

5WRRNKGF"#PVGPPC

To attach the supplied flexible antenna to the antenna jack on top of your scanner, align the slots around the antenna's connector with the tabs on the antenna jack. Press the antenna down over the jack and turn the antenna's base clockwise until it locks into place.

%100'%6+0)"#0"

176&114"#06'00#

The antenna connector on your scanner makes it easy to use the scanner with a variety of antennas, such as an external mobile antenna or outdoor base station antenna. Your local RadioShack store sells a variety of antennas.

10

Page 10
Image 10
Radio Shack PRO-82 manual Qppgevkpivjg 5WRRNKGF#PVGPPC, 7UKPI8GJKENG$CVVGT 2QYGT