Special Features
#"+/2146#06"#
If you have problems, first try to reset the scanner (see “Resetting the Scanner” on Page 38). If that does not work, you can initialize the scanner (see “Initializing the Scanner !” on Page 39); however, this clears all information stored in your scanner's memory.
#XQKFKPI"+OCIG"
(TGSWGPEKGU
You might hear one of your regular stations on another frequency that is not listed. For example, you might find a service that regularly uses a frequency of 453.275 also on 474.675 MHz. Do the following to determine if you are listening to an image frequency:
Note the new frequency 474.675
Double the intermediate frequency
of 10.7 MHz | (21.400) |
and subtract it from the new
frequency–21.400
If the answer is the regular
frequency453.275
then you have tuned to an image.
Occasionally, you might get interference on a weak or distant channel from a strong transmission 21.4 MHz above or below the tuned frequency. This is rare, and the image signal is usually cleared whenever there is a transmission on the actual frequency.
4GUGVVKPI1+PKVKCNK\KPI"VJG"
5ECPPGT
If the scanner's display locks up or does not work properly after you connect a power source, you might need to reset or initialize the scanner. #
4'5'66+0)"6*'"5%#00'4
1.Turn off the scanner, then turn it on again.
38
