Note: You must store frequencies into channels before the scanner can scan them. The scanner does not scan empty channels.
The scanner scans through all channels (except those you have locked out) in the active banks (see “Turning
Turning Channel-Storage Banks Off and On
To turn off banks while scanning, press the bank’s num- ber key until the bank’s number disappears. The scan- ner does not scan any of the channels within the banks you have turned off.
Notes:
•You cannot turn off all banks. There must be at least one active bank.
•You can manually select any channel in a bank, even if the bank is turned off.
To turn on banks while scanning, press the number key until the bank’s number appears.
MANUALLY TUNING A FREQUENCY
1.Press TUNE.
2.Use the number keys to enter the frequency.
3.Press ENTER.
4.Press 
to move up one tuning step. Press 
to move down one tuning step. To move up or down in 1 MHz increments, press FUNC then 
or 
for each increment.
To save the frequency into a channel (bank 9 only), press FUNC then ENTER. Stored @ 9xx appears (xx is the channel number).
When the scanner stops on a frequency while searching, press FUNC then TUNE.
38Operation
