Storing Talk Group IDs
To store a talk group ID when scanning, press TRUNK when the scanner stops on a transmission. The bottom line changes to ID#XXXX, indicating that the ID is stored.
Note: When you try to store more than 100 talk group IDs in a bank, Memory full! appears. Clear some talk group IDs in order to store new ones (see “Clearing Talk Group IDs” on Page 56).
Follow these steps to manually store talk group IDs or to edit a stored ID.
1.Press PGM.
2.Press TRUNK.
3.To select the bank where you want to store the ID, press FUNC then 
or 
.
4.Press MODE to select LT, MO, or ED.
5.Enter the talk group ID and press ENTER. If neces- sary, use the decimal point for a hyphen.
Note: If you made a mistake in Step 4, Invalid ID. appears and the scanner beeps when you press ENTER. Start again at Step 3.
6.Press TEXT and enter the text tag for the ID, then press ENTER.
7.To store the next ID memory in sequence, press 
and repeat Steps 4 and 5 to enter more IDs.
8.Press SCAN to start scanning.
Talk Group ID Hold
You can set your scanner to follow a trunking signal that you want to track during scanning. Hold down TRUNK for more than 2 seconds. ID hold ON. appears.
To release ID hold, press SCAN or TRUNK.
Trunking Operation | 55 |
