Chapter 4 Replacing Cisco 7201
Removing and Installing a Port Adapter or Service Adapter
Figure 4-4 Installing a Port Adapter or Service Adapter
3
ENABLEDR | RX | RX | |
| S |
| IER |
| ELL | R | RM |
XC | CAR | ALA | |
ATM 
1
2
SL
| BIT |
|
|
|
|
|
|
|
|
|
|
| R | R |
|
|
|
|
|
| Cisco | R |
|
|
|
|
|
| |
RJ45 | 7201 |
|
| GB |
| EN | 0/ | AU | |
EN | LINK/ACTV |
|
|
|
|
| K | ||
|
| SFP | RJ45 | EN | LINK/ACTV |
|
|
| |
|
|
|
| TX | SFP | RX | LINK/ACTV | LINK/ACTV | |
|
|
|
|
|
| SFP | |||
| GE 0/0 |
|
|
|
|
| TX | SFP | RX |
|
|
|
| GE 0/1 |
|
|
|
|
|
|
|
|
|
|
|
| GE 0/2 | GE 0/3 |
|
|
|
|
|
|
|
|
| AUX | |
NS |
|
|
MNGMNT |
|
|
USE ONLYFL |
| |
FE 0/0 | FE | 0 |
| LINK |
|
S
COMPACT FLASH
ALARM 
PWR OK 
STATUS 
CF ACTV
170872
1
2
Port adapter lever | 3 Port adapter slot guide |
Port adapter
Follow these steps for inserting and securing a port adapter:
Step 1 Attach an
Step 3 Remove the port adapter from the chassis slot by sliding the port adapter lever to the right, in the unlocked position.
Step 4 Grasp the handle and pull the port adapter or port adapter blank panel from the router.
Step 5 Locate the port adapter slot guides inside the Cisco 7201 router. They are near the top, and are recessed about
Caution The port adapter must slide into the slot guides under the chassis lid. Do not allow the port adapter components to come in contact with the system board or the port adapter could be damaged.
Step 6 Carefully slide the port adapter into the port adapter slot and seat it. When installed, the port adapter input/output panel should be flush with the face of the router.
Step 7 Slide the port adapter lever left to the locked position.
Step 8 Reconnect any cables, including the port adapter and power cables, and place the cables through any
Step 9 Power on the router by turning the power switch to the on (O) position.
Note If the port adapter fails to come up, reseat or reinsert the port adapter: do not use excessive force.
Cisco 7201 Installation and Configuration Guide
| ||
|
