Chapter 3 Starting and Configuring the Router

Configuring a Cisco 7201 Router

Configuring Global Parameters

When you first start the setup program, you must configure the global parameters. These parameters are used for controlling system-wide settings. Complete the following steps to enter the global parameters:

Step 1 Connect a console terminal to the console port, and then boot the router.

The system boots from flash memory. The following information appears after about 30 seconds. When you see this information, you have successfully booted your router:

Restricted Rights Legend

Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph

(c)of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph

(c)(1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco IOS Software, 7200 Software (C7200P-ADVENTERPRISEK9-M), Version 12.4(TAZ3XD.2006-12-03), INTERIM SOFTWARE

Copyright (c) 1986-2006 by Cisco Systems, Inc. Compiled Sun 03-Dec-06 00:44 by

Image text-base: 0x0000A3F8, data-base: 0x0327A000

This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer and use. Delivery of Cisco cryptographic products does not imply third-party authority to import, export, distribute or use encryption. Importers, exporters, distributors and users are responsible for compliance with U.S. and local country laws. By using this product you agree to comply with applicable laws and regulations. If you are unable to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at: http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to export@cisco.com.

Cisco 7201 (c7201) processor (revision A) with 917504K/65536K bytes of memory. Processor board ID 4294967295

MPC7448 CPU at 1666Mhz, Implementation 0, Rev 2.1 1 slot midplane, Version 2.255

Last reset from power-on 1 FastEthernet interface

4 Gigabit Ethernet interfaces

4 Channelized T1/PRI ports

2045K bytes of NVRAM.

250200K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).

65536K bytes of Flash internal SIMM (Sector size 512K).

Press RETURN to get started!

 

 

Cisco 7201 Installation and Configuration Guide

 

 

 

 

 

 

OL-11364-04

 

 

3-11

 

 

 

 

 

Page 75
Image 75
Cisco Systems CISCO7201 manual Configuring Global Parameters, Restricted Rights Legend