Cisco Systems CISCO7201 manual Four-Post Rack Installation

Chapter 2 Installing the Cisco 7201 Router

Installing the Router

Four-Post Rack Installation

Note Inner clearance (the width between the inner sides of the two posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is 1.73 inches (4.39 cm). Airflow through the chassis is from front to back.

Figure 2-7 Installing the Cisco 7201 Router in a Four-Post Rack

1

	ED	CELLS	ARRIER	R
ENA	BL		ALA	M
	RX	XC
		R	RX

2

ATM

RJ45

PA

SLOT 1

Cisco

EN

GE 0/0

7201
LINK/A								CONSOLE
CTV	RJ45
SFP		EN	LINK/ACTV
					LINK/ACTV
		TX	SFP	RX			LINK/ACTV
					SFP	TX
							SFP	RX

MNGMNT USE ONLY
GE 0/1
GE 0/2			ALARM
GE 0/3
AUX	FE	0	PWR	OK
FE 0/0
	LINK	COMPACT	STATUS
		FLASH	CF
			ACTV
		3

281127

1

2

Four-post rack 3 Four 10-32 or 12-24 screws

Screw hole for the cable-management bracket

Step 1 Make sure that the port adapter lever is in the locked position.

Step 2 Make sure the rack brakes are locked or the rack is stabilized.

Step 3 Position the router so the front is closest to you and lift it carefully into the rack. To prevent injury, avoid any sudden twists or moves.

Step 4 Slide the chassis into the rack, pushing it back until the brackets meet the mounting strips or posts on both sides of the rack.

Step 5 Keeping the brackets flush against the posts or mounting strips, align the holes in the brackets with the holes on the rack or mounting strip.

Step 6 For each bracket, insert and tighten two 10-32 or 12-24 screws to the rack.

This completes the procedure for installing the chassis in the rack. Proceed to the “Attaching a Chassis Ground Connection” section on page 2-12to continue the installation.

	Cisco 7201 Installation and Configuration Guide
OL-11364-04		2-11