Cisco Systems CISCO7201 manual Negative Return +, Inserting Wires into the Terminal Block Plug

Chapter 2 Installing the Cisco 7201 Router

Connecting Power

Figure 2-29 Inserting Wires into the Terminal Block Plug

1

2

	1
	A
	2
	3
	B
	4
	170975
Negative (–)	3	Negative (–)
Return (+)	4	Return (+)

Step 7 Insert the exposed wire of one of the four DC-input power source wires into the terminal block plug, as shown in Figure 2-29. Make sure that you cannot see any wire lead. Only wire with insulation should extend from the terminal block.

Figure 2-30 Torquing the Terminal Block Plug Captive Screws

1

1

170974

Torque is from 0.5 Nm (4.425 lbf in. to 0.6 Nm (5.310 lbf in.)

Caution Do not overtorque the terminal block plug captive screws. The recommended maximum torque is from 0.5 Nm (4.425 lbf in.) to 0.6 Nm (5.310 lbf in.).

	Cisco 7201 Installation and Configuration Guide
OL-11364-04		2-31