
Chapter 2 Installing the Cisco 7201 Router
Connecting Power
Step 8 Use a ratcheting torque screwdriver to torque the terminal block plug captive screw (above the installed wire lead) to from 0.5 Nm (4.425 lbf in. to 0.6 Nm (5.310 lbf in.), as shown in Figure
Figure 2-31 Completed Wiring of Terminal Block Plug
1 |
A |
2 |
3 |
B |
4 |
170972
1
2
Negative
Return (+)
3Negative
4Return (+)
Step 9 Repeat Step 6 and Step 7 for the remaining three
Note Each DC power supply accepts two power feeds, but works with only one. You may choose to install only one power feed per power supply. For example, DC power feed A to the power supply in power supply slot 1 and DC power feed B to the power supply in power supply slot 2.
| Cisco 7201 Installation and Configuration Guide |