Chapter 4 Replacing Cisco 7201
Removing and Installing a Port Adapter or Service Adapter
Step 2 Insert a Cisco USB flash memory module or the Aladdin USB eToken Pro key into the Cisco 7201 USB port as shown in Figure
This completes the USB Flash memory or Aladdin USB eToken Pro key installation procedure.
Note For detailed information about the Cisco IOS commands that support USB Flash memory modules, see the USB Storage document.
Removing and Installing a Port Adapter or Service Adapter
The information in this section also applies to service adapters.
Warning During these procedures, wear grounding wrist straps to avoid ESD damage to the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Before removing any port adapter, gracefully shut down the interface so that there is no traffic running through the port adapter when it is removed. Removing a port adapter while traffic is flowing through the ports can cause system disruption.
The Cisco 7201 router supports OIR of the port adapter. However, if you choose to power off the router to remove or install a port adapter, turn the power switch to the standby () position and then remove the power cable. After you have replaced the port adapter or inserted a port adapter blank panel, replace the power cable and then turn the power switch to the on (O) position.
Note After powering off the router, wait at least 30 seconds before powering it on again.
Cisco 7201 Installation and Configuration Guide
|
| ||
|
|
