DISABLING THE LINE 2 INDICATOR
If you have only one telephone line, the LINE 2 indicator lights and LINE 2 EX- TENSION appears on the display. Follow these steps to disable the LINE 2 indica- tor.
1.Press REVIEW 8 or 9 repeatedly until the call total appears.
2.Press REVIEW 9 until LINE 2 EN- ABLED appears (about 3 seconds).
3.Press REVIEW 8 or 9. LINE 2 DISABLED appears.
4.Press DELETE to return to the cur- rent time display.
ADJUSTING THE DISPLAY CONTRAST
1.Press REVIEW 8#or 9 repeated- ly until the call total appears.
2.Press and hold down REVIEW 8 for about 3 seconds until CONTRAST X appears.
3.Within 30 seconds, repeatedly press REVIEW 8 or 9 to adjust the dis- play’s contrast from 1 to 8.
Notes:
•If CONTRAST X disappears before you press REVIEW 8 or#9, re- peat Steps
•If you did not connect an AC adapter, you can only adjust the display contrast from 1 to 3, and
12
only after you pick up the hand- set.
4.When you finish adjusting the con- trast, press DELETE to return to the main display.
SETTING THE RINGER VOLUME
To set the ringer’s volume for LINE 1 or LINE 2, set the correlating L1 RINGER or L2 RINGER to HIGH, LOW, or OFF.
Note: You can still answer calls if you hear an extension phone ringing, and you can still make calls.
SETTING THE DIALING MODE
Set TONE/PULSE for the type of service you have, tone or pulse. If you are not sure which type you have, do this test.
1.Set TONE/PULSE to TONE.
2.Pick up the handset and listen for a dial tone.
