On a Desk Top
Follow these steps to mount the system on a desktop.
1.Plug one end of the supplied long modular cord into the TEL LINE jack on the back of the phone.
2.Plug the other end of the modular cord into a modular phone jack.
3.Place the phone on a flat desk, shelf, or table.
On a Wall Plate
Follow these steps to mount the system on a standard wall plate.
1.Plug one end of the supplied short modular cord into the TEL LINE jack on the back of the system. Then route the cord through the strain re- lief groove on the bottom of the phone.
Strain Relief
Groove
Key Hole Slots
2.Feed any excess modular cord into the cavity at the base of the strain relief groove.
3.Plug the other end of the modular cord into the wall plate’s modular jack.
10
4.Align the base’s keyhole slots with the wall plate studs and slide the base downward to secure it.
5.Press and lift out the handset hold- er. Rotate it 180°, then snap it back into place so it holds the handset.
Handset
Holder 
On the Wall
To install the system directly on the wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the phone and the stand.
1. Drill two holes 315/16 inch- | 1/8 | ||||
es (100 mm) apart. Then |
|
|
|
|
|
|
|
|
|
| |
thread a screw into each |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
| |
hole, letting the heads ex- |
|
|
|
|
|
tend about 1/8 inch (3.5 |
|
|
|
|
|
315/16 |
|
|
| ||
mm) from the wall.
2.Plug one end of the supplied long modular cord into the TEL LINE jack on the back of the system.
3.Align the bracket’s keyhole slots with the mounting screws and slide the base downward to secure it.
4.Plug the other end of the modular cord into a nearby modular jack.
