Fitting the open array to the pedestal | Raymarine Radar Scanner

Chapter 2: Installing the Scanner

33

Fitting the open array to the pedestal

CAUTION:

The pedestal unit has a cap fitted over the open array mounting shaft to protect the protuding co-axial pin. This cap must be left in place until the open array is fitted to the pedestal.

1.Remove the cap from the open array shaft. Retain the cap, it will be required if the open array is removed from the pedestal.

2.Grease the four securing studs.

CAUTION:

If the pin is damaged during the following operation you should contact your service dealer.

3.Lift the open array into position. Carefully lower the array - to pre- vent damage to the mounting pin, ensure the array remains paral- lel to the pedestal so that the studs slot into the holes on the pedestal mounting bracket.

Note: The open array mounting bracket is designed so that the array can only be fitted to the pedestal in the correct orientation.

4.Use the four nuts and associated washers supplied to secure the array to the pedestal as shown in the diagram below.

Array

Pedestal

M8 plain washer

M8 spring washer

M8 nut

D4580-2

Image 41

Raymarine Radar Scanner manual Fitting the open array to the pedestal

Contents

Pathfinder Radar Scanners Page October Pathfinder Radar Scanners Owners Handbook Pathfinder Radar Scanners Display Software Version Preface Warranty Contents Appendix a Introduction Overview This handbook is divided into three chapters as follows EMC installation guidelines Connections to Other Equipment Option Unpacking and inspecting the componentsSupplied with For Supplied with Option for Selecting the scanner unit site Radome Scanner Open Array Scanners Weight Pathfinder Radar Scanners Mounting surface sailboats Mounting surface power boats Ideal Radiation Plane Setting the radiation plane Rejoining Cables Cable runs Scanner Package Inter-Unit Cable Inter-unit cable 2DE Eur Radome scanner cablesInter-Unit Cable Scanner Package Power cable Inter-Unit Cables Radome Scanner Systems 4 kW scanners only Open array scanner cables32 V Systems 4 kW scanners Inter-Unit Cable KW Scanners 32 V Systems 10kW scanners 32 V systems Power Cable Core Size each core KW Scanners Pathfinder Radar Scanners Installing the Scanner Connecting the radome scanner inter-unit cable Inner cover White wire Installing the Scanner Pathfinder Radar Scanners Open array scanner Securing the pedestal to the mounting platform Connecting the open array scanner inter-unit cable Heatshrink Heat Shrinking of Wires Do not grease the gasket in the pedestal lid Fitting the open array to the pedestal Power Connections DC power connectionSystem connections Grounding the radar system Vessels Device Open Array Systems Radome Supply 10 kW Scanner connection Scanner Front view Display Cable ConnectorDisplay Display unit connection Connector Panels Pathfinder Radar Scanners Switch on and initial set up Set up, alignment and timing checksSystem Checks and Alignment EMC Conformance Open array position alignment Display timing adjustmentChecking transmission Bearing alignment Routine Checks MaintenanceServicing and Safety Problem Correction Problem Solving For Marine Product and Services Information How to Contact Raytheon USFor Accessories and Parts For Technical Support For Product Repair and Service How to Contact Raytheon Europe Technical Support Accessories and PartsWorldwide Support Pathfinder Radar Scanners General 2D 18 Radome Scanner UnitTransmitter Antenna Receiver 4D 24 Radome Scanner Unit Including Low Noise Converter/Limiter & if Receiver Pulse Length/PRF 5S and 9S 48 Open Array Scanner Unit 9S Transmitter 10 kW Appendix a Specification Receiver Noise Figure Less than 5 dB 7S Transmitter 4 kW 7S and 11S 72 Open Array Scanner Unit 11S Transmitter 10 kW Appendix a Specification Pathfinder Radar Scanners Index Pathfinder Radar Scanners