Pathfinder Radar Scanners | Raymarine guide

26	Pathfinder Radar Scanners

ing on the thickness of the cable: use the position that matches the profile of the cable.

CAUTION:

It is essential that the drain tube is fitted and that the nut on the watertight gland is adequately tightened. If this is not done, water could become trapped in the scanner and cause irreparable damage.

13.Tighten the securing nut (1) again to ensure a waterproof seal.

14.If you have a 4D scanner, replace the inner cover over the connec- tors.

15.Untie the cord from the scanner cover, and coil it up in the base of the scanner unit so that it cannot foul the rotating antenna.

16.Replace the scanner cover, aligning the mark on the cover with the mark on the scanner base above the cable gland, and tighten the 4 or 7 captive screws. Do not over-tighten these screws.

Image 34

Raymarine manual Pathfinder Radar Scanners

Contents

Pathfinder Radar Scanners Page Pathfinder Radar Scanners Owners Handbook October Pathfinder Radar Scanners Preface Display Software Version Warranty Contents Appendix a Overview Introduction EMC installation guidelines This handbook is divided into three chapters as follows Connections to Other Equipment Supplied with For Unpacking and inspecting the componentsOption Supplied with Option for Selecting the scanner unit site Radome Scanner Weight Open Array Scanners Pathfinder Radar Scanners Mounting surface power boats Mounting surface sailboats Setting the radiation plane Ideal Radiation Plane Cable runs Rejoining Cables Inter-unit cable Scanner Package Inter-Unit Cable Inter-Unit Cable Scanner Package Radome scanner cables2DE Eur Power cable Radome Scanner Inter-Unit Cables 32 V Systems 4 kW scanners Open array scanner cablesSystems 4 kW scanners only Inter-Unit Cable KW Scanners 32 V Systems 10kW scanners Power Cable Core Size each core 32 V systems KW Scanners Pathfinder Radar Scanners Installing the Scanner Connecting the radome scanner inter-unit cable Inner cover White wire Installing the Scanner Pathfinder Radar Scanners Open array scanner Securing the pedestal to the mounting platform Connecting the open array scanner inter-unit cable Heatshrink Heat Shrinking of Wires Do not grease the gasket in the pedestal lid Fitting the open array to the pedestal System connections DC power connectionPower Connections Grounding the radar system Scanner connection Vessels Device Open Array Systems Radome Supply 10 kW Display Front view Display Cable ConnectorScanner Connector Panels Display unit connection Pathfinder Radar Scanners System Checks and Alignment Set up, alignment and timing checksSwitch on and initial set up EMC Conformance Checking transmission Display timing adjustmentOpen array position alignment Bearing alignment Servicing and Safety MaintenanceRoutine Checks Problem Solving Problem Correction For Accessories and Parts How to Contact Raytheon USFor Marine Product and Services Information For Technical Support How to Contact Raytheon Europe For Product Repair and Service Worldwide Support Accessories and PartsTechnical Support Pathfinder Radar Scanners Transmitter 2D 18 Radome Scanner UnitGeneral Antenna 4D 24 Radome Scanner Unit Receiver Including Low Noise Converter/Limiter & if Receiver 5S and 9S 48 Open Array Scanner Unit Pulse Length/PRF Appendix a Specification 9S Transmitter 10 kW Receiver Noise Figure Less than 5 dB 7S and 11S 72 Open Array Scanner Unit 7S Transmitter 4 kW 11S Transmitter 10 kW Appendix a Specification Pathfinder Radar Scanners Index Pathfinder Radar Scanners