Appendix a Specification | Raymarine Radar Scanner guide

Appendix A: Specification							51

	9S Transmitter - 10 kW

	Input Voltage		16 - 44 V DC (from display unit)

	Power Consumption		11 W Standby
			80 W Typical operation in light winds
			95 W Max. operation in 50 Kt winds
			140 W Max. operation in 100 Kt windS

	Transmitter Frequency		9410 +/– 30 MHz

	Peak Power Output		10 kW (nominal)

	Transmitter		Solid state modulator driving magnetron

	Pulse Length/PRF		Normal		Expanded
			Normal		Expanded
	Range	Pulse Length	PRF	Bandwidth	Pulse Length	PRF	Bandwidth
	(nm)	(∝ S)	(Hz)	(MHz)	(∝ S)	(Hz)	(MHz)
0.125		0.065	3000	12	0.09	3000	12
0.25		0.065	3000	12	0.09	3000	12
0.50		0.09	3000	12	0.15	3000	12
0.75		0.15	3000	12	0.25	3000	12
1.50		0.35	2000	3	0.45	1600	3
3.00		0.45	1600	3	0.60	1200	0.7
6.0 - 72		1.20	740	0.5	-	-	-

	Standby Mode		Magnetron heater and control left on, all other services off

	Duplexer		Circulator with integral limiter


	48" Antenna

	Antenna Type		Slotted waveguide array

	Beam Width (nominal)		1.85°

	Polarization		Horizontal

	Antenna Side lobes		Less than -22 dB

	Rotation Rate		24 rpm (nominal)

Image 59

Raymarine Radar Scanner manual Appendix a Specification, 9S Transmitter 10 kW

Contents

Pathfinder Radar Scanners Page October Pathfinder Radar Scanners Owners Handbook Pathfinder Radar Scanners Display Software Version Preface Warranty Contents Appendix a Introduction Overview This handbook is divided into three chapters as follows EMC installation guidelines Connections to Other Equipment Supplied with Option for Unpacking and inspecting the componentsOption Supplied with For Selecting the scanner unit site Radome Scanner Open Array Scanners Weight Pathfinder Radar Scanners Mounting surface sailboats Mounting surface power boats Ideal Radiation Plane Setting the radiation plane Rejoining Cables Cable runs Scanner Package Inter-Unit Cable Inter-unit cable 2DE Eur Radome scanner cablesInter-Unit Cable Scanner Package Power cable Inter-Unit Cables Radome Scanner Inter-Unit Cable KW Scanners Open array scanner cablesSystems 4 kW scanners only 32 V Systems 4 kW scanners 32 V Systems 10kW scanners 32 V systems Power Cable Core Size each core KW Scanners Pathfinder Radar Scanners Installing the Scanner Connecting the radome scanner inter-unit cable Inner cover White wire Installing the Scanner Pathfinder Radar Scanners Open array scanner Securing the pedestal to the mounting platform Connecting the open array scanner inter-unit cable Heatshrink Heat Shrinking of Wires Do not grease the gasket in the pedestal lid Fitting the open array to the pedestal Grounding the radar system DC power connectionPower Connections System connections Vessels Device Open Array Systems Radome Supply 10 kW Scanner connection Scanner Front view Display Cable ConnectorDisplay Display unit connection Connector Panels Pathfinder Radar Scanners EMC Conformance Set up, alignment and timing checksSwitch on and initial set up System Checks and Alignment Bearing alignment Display timing adjustmentOpen array position alignment Checking transmission Routine Checks MaintenanceServicing and Safety Problem Correction Problem Solving For Technical Support How to Contact Raytheon USFor Marine Product and Services Information For Accessories and Parts For Product Repair and Service How to Contact Raytheon Europe Technical Support Accessories and PartsWorldwide Support Pathfinder Radar Scanners Antenna 2D 18 Radome Scanner UnitGeneral Transmitter Receiver 4D 24 Radome Scanner Unit Including Low Noise Converter/Limiter & if Receiver Pulse Length/PRF 5S and 9S 48 Open Array Scanner Unit 9S Transmitter 10 kW Appendix a Specification Receiver Noise Figure Less than 5 dB 7S Transmitter 4 kW 7S and 11S 72 Open Array Scanner Unit 11S Transmitter 10 kW Appendix a Specification Pathfinder Radar Scanners Index Pathfinder Radar Scanners