Chapter 3: Installation 19
2. Applythe surface mount template (supplied at the rear of this hand-
book)to the selected location and markt hecentres for the fixing studs
(1)and the ap erture (3) that will ta ke the rear casing of th e instrument.
3. Drillout the two 5 mm fixing stud clearance holes (2).
4. Cutout the clearance hole (3) then remove the template.
5. Peeloff the protective sheet from the self-adhesive gasket (4) then
stickthe gasket into position on the rear of the instrument.
6. Screwthe two fixing studs into the threaded sockets on the rear of the
instrument.
7. Mountthe assembled instrument, studs, bezel and gasket into the
panel.Secure from behind with the thumb nuts (5).
Flush mounting
TheFlush Mounting Kit uses a low-profile bezel to reduce the fitted
profileof the instrument, to approximately 6 mm above the panel fascia.
D4343-2
Surface mounting
11223455
81040_1.book Page19 Thursday, November7, 2002 10:21AM