Slave Unit:
See Staging Table
|
|
| Screen number |
S L A V E S | C | O N N E C T E D | 2 5 |
# | X X |
|
|
Number of slaves connected: 01 thru 04
A unit with no sensors attached to it defines itself as the SLAVE unit. In program mode (see page 32) you identify which SLAVE unit you want it to be. SLAVE units are numbered from 1 to 4.
Connect the master unit to each slave unit in parallel using RS485 wiring as noted in the Communications (RS485) Wiring section of this manual.
LonWorks (Optional):
Screen number
L | O | N W O R K S | 2 6 |
O | F | F |
|
OFF
ON
If ON, the LonWorks network is active.
Factory Defaults: |
|
| Screen number |
|
|
| |
F A C T O R Y | D | E F A U L T S | 2 7 |
| N | O |
|
Press MODE button to get into program mode.
Press UP arrow key to select YES.
Press MODE button to load Factory Defaults and to exit program mode.
NOTE: If unit times out the factory defaults will not be set.
31
