RayTek ThermoView Ti30 user manual Turning the Unit On, Displaying Images

Turning the Unit On

Power is switched on or off by opening or closing the lens door. Sliding down the lens door turns the imager on (see Figure 6 below). Slide the door up to turn off the imager.

Closed

(Unit Off)

Open

(Unit On)

Figure 6. Powering the ThermoView Imager On and Off

Note: The unit is self-protected against excessive levels of infrared radiation and it will cause the unit to automatically shut down. If that happens, slide the lens door closed, wait a minute and slide it open again.

Important: Always dock the imager in the docking station when not in use. By doing so, you will assure the batteries will be always fully charged when using the rechargeable battery pack. The image will not show thermal images or respond to controls while it is in the docking station.

Displaying Images

The ThermoView imager performs an initial auto-check each time it is activated and then immediately shows the Information Screen. The Information Screen displays the following information about the ThermoView imager unit:

July 1, 2003 - 15 - Version 1.0

i Tel: (01943) 602001- WWW.ISSLTD.CO.UK - Fax: (01943) 816796 i