Chapter 2

Local Network Setup

2.1 Wired Ethernet

Local network The Ethernet ports on the backpanel allow you to connect the SpeedTouch™ to an existing 10 or 100 Base-T Ethernet network or one (or more) computer(s) with installed Ethernet card.

Using the SpeedTouch™ Ethernet switch, you can create a local Ethernet network of up to four devices, without needing extra networking devices.

In the SpeedTouch™ package, a yellow full-wired straight-through RJ-45/RJ- 45 Ethernet cable is included.

Standard wiring Use the yellow Ethernet cable provided to wire your computer's Ethernet port to one procedure of the SpeedTouch™'s Ethernet ports.

The Ethernet cable can also be used to wire any Ethernet port of your SpeedTouch™ to an external hub or switch.

Please follow the installation instructions supplied with the external hub or switch for connections and Ethernet cabling.

Ethernet link check Depending on the SpeedTouch™ model, LED indicators allow you to check your Ethernet. See “1.2 SpeedTouch™ LED Behaviour” on page 8 for more information.

Device settings Once you’ve connected a device, you are able to personalise its settings.

For more information, see “ Device settings” on page 17.

18

E-DOC-CTC-20050429-0099 v1.0

 

Page 26
Image 26
RCA 536 manual Wired Ethernet, For more information, see Device settings on