RCA CC4251 manual Playback on a TV Without Audio/Video Inputs

Playback

Playback on a TV Without Audio/Video Inputs

To connect your camcorder to a TV without audio/video inputs, you need an optional CRF95 RF output adapter and an optional coaxial RF cable, such as VH82 or VH90 shown on page 43. If your TV has audio and video inputs (or is connected to a VCR), refer to pages 36-37.

Antenna

OR OR

Antenna

Back of TV

Optional 300/75 ohm Transformer

VHF

OR

Channel Selector

VHF

	IN
	FROM
Optional 75-300 Ohm	ANT	Optional RF Output Adapter
Transformer		(such as CRF95)
(such as VH54
Optional Coaxial RF Cable		OUT
(such as VH82 or VH90)		TO TV

Installation

1.Disconnect the VHF antenna from your TV. Connect the antenna to the IN FROM ANT connector on the RF output adapter if you are going to leave the adapter connected to the TV.

Note: If your VHF antenna is the flat twin-lead type attached by two screws, you need an optional 300/75 ohm transformer.

2.Attach one end of the optional coaxial RF cable to the OUT TO TV connector on the adapter, and attach the other end to the VHF input on your TV as shown.

Note: If your TV has 300 ohm screw terminals, you need a 75/300 ohm transformer, such as VH54, shown on page 43.

3.Attach the RF output adapter’s yellow plug to the VIDEO jack, the small plug to the RF DC OUT jack, and the white plug to the AUDIO jack located under the small cover on the side of the camcorder.

38