RCA DRC8300N manual Connections and Setup, Dvd/Vcr, Ac-In

Chapter 1: Connections and Setup

CABLE/ANTENNA

INPUT

CABLE/ANTENNA

OUTPUT

CH3 CH4

DVD/VCR

INPUT S-VIDEO OUTPUT

VIDEO	VIDEO
L	IN
	L
AUDIO	AUDIO
	OUT
R	R

DVD Playback Only

COMPONENT	DIGITAL
VIDEO OUTPUT	AUDIO OUT
Y
Pb

Pr

PROG.

SCAN

OPTICAL OFF ON

AC-IN

OUTPUT: These jacks send the content (audio and video) from your DVD/VCR OUT to the TV so you can see it on the TV screen and hear it through the TV’s speakers.

VIDEO: Color coded yellow, the video cable you use with this jack provides better quality than an RF Coaxial cable but isn’t as good as S-Video.

AUDIO L (left): Color coded white, connect corresponding audio cable to TV’s Audio Left Input Jack.

AUDIO R (right): Color coded red, connect corresponding audio cable to TV’s Audio Right Input Jack.

COMPONENT VIDEO OUTPUT (Y, Pb, Pr) - DVD PLAYBACK ONLY: Some high-end TVs and monitors have Component Video Input jacks. The cables that send the video signal through these Output Jacks provide the highest resolution because the video signal is divided into 3 separate parts (cables not supplied with DVD/VCR). As with VIDEO and S-VIDEO, COMPONENT VIDEO (Y, Pb, Pr) only carries the picture signal so you need to connect the audio cables so you’ll hear the sound. If your TV has COMPONENT INPUT jacks, use three video grade cables to connect the DVD/VCR to these jacks on the TV to get the best picture quality. However, make sure you also connect another video cable (either a RF coaxial cable to the CABLE/ANTENNA OUTPUT jack; the yellow cable to the VIDEO Output jack; or an S-Video cable to the S-VIDEO OUT jack) because you can only use Component Video for DVD Playback. You’ll need to have another Video Output connected for playback of VCR tapes.

DIGITAL AUDIO OPTICAL OUT - DVD PLAYBACK ONLY: If you have a Dolby Digital or DTS receiver or decoder with a Digital Audio Optical Input jack, you can achieve enhanced sound quality during DVD PLAYBACK by connecting a digital optical cable (not supplied).

Note: Make sure you connect regular audio cables in addition to connecting a Digital Audio cable because you can only use the DIGITAL AUDIO connection for DVD Playback. If you’re playing a VCR tape in analog mode (necessary for recording to DVD disc and playing a tape at the same time) you’ll need the other audio cables connected because the sound from the DIGITAL AUDIO won’t match up with the video in analog mode causing a “a lip sync” problem.

PROG. SCAN switch – If you’ve connected your DVD/VCR to a TV that uses progressive scanning to display the image via the Y, Pb, Pr jacks, turn the switch to the “on” position for progressive scan playback of DVD discs. Typically, only some High Definition Televisions and high-end multimedia monitors use progressive scanning. Leave the switch in the OFF position for S-VIDEO or regular VIDEO (yellow) connections.

Note: If you turn the PROG SCAN switch on, and your TV isn’t capable of progressive scanning you won’t see a clear picture on the TV screen. Additionally, when playing DVDs you won’t see any picture—press STOP (the main menu appears) and turn the PROG SCAN switch to the OFF position. Try playing the disc again.

AC-IN – This is where you attach the power cord.

6 Graphics contained within this publication are for representation only.