Using ‘Fwo VCRs for Copying and Editing ~Tapes
Operating InStructions (Refer t0 hookup 0n page 6.)
Use one VCR as the playback VCR and the other as the recording VCR. If you have two compatible VCRs, use the AutoEditTM feature describedbelow.
recording of television pro- grams and other materials may inhinge the rights of
1.Turn on the TV and VCRs.
2.Tune TV to the VCR viewing channel, either 3,4, or TV’s video input.
3.If you have connected your VCR using Option A (page6), tune recording VCR to channel 3 or 4 - the one selected on the back of the playback VCR.
If you have connected your VCR using Option B (page 6), press INPUT on recording VCR’s remote to select the line input.
4.Insert the tape you want to copy into playback VCR. Insert a blank tape with safety tab in place into recording VCR.
5.Press PLAY, then PAUSE on playback VCR when you reach the point on the tape or program where you want to begin copying. If the tape was not recorded on the playback VCR, streaks may appear and you may need to adjust TRACKING.
6.Press REC*OTR, then PAUSE, on recording VCR.
7.Press PAUSE buttons on both VCRs at the’same time to begin copying the tape.*
8.Edit out segments that you do not want to copy by pressing PAUSE on recording VCR to stop copying the tape. Then, locate the next segment you want to copy on playback VCR by using F.FWD, REWIND, and PLAY. Press PAUSE on the playback VCR. Press PAUSE at the same time on both VCRs to resume copying.
9.Press STOP on both VCRs when you are finished.
*You may turn off the TV after the recording has started as it does not have to be on to copy a tape.
Using Dual Remote with AutoEdit’”
Use this VCR as the recording VCR and set it to respond to VCR2 on the remote as describedon page 22. Use your other compatible VCR as the playback VCR, which should respond to VCR1 .
1.Follow steps l- 4 in the “Operating Instructions” above.
2.PressVCR2 on remote to control recording VCR. Press REC*OTR, then PAUSE, to put recording VCR in pause mode.
3.Press VCR1 on remote to control playback VCR.
4.Use F.FWD, REW. and PLAY to locate the point where you want to begin copying. Press PAUSE while VCR is playing to put playback VCR in pause mode.
5.Press EDIT on remote; the VCRs will begin copying.
6.Press EDIT again when you want to stop the tape from copying.
7.Repeat steps 4 - 6 as needed.
8.Press VCRl, STOP, then VCR2, STOP, when you are finished.
26
