INSTALLATION
INSTALLATION
6)Peel off the tape from the velcro strips and mount the DC Sparker to the velcro on the inside of the right faceplate panel as shown in diagram 5. Install batteries into the DC Sparker (batteries are included with packaged manual).
NOTE: The DC Sparker comes with the unit. It is cable tied to the top left side mounting bracket.
DC Sparker
9)Close the right side faceplate panel.
10)Remove the remote receiver bracket from the left side of the unit by undoing the 2 screws. See diagram 8.
Remote Receiver
Bracket
Diagram 8
11) Remove the grommet from the bracket on the left side of the unit. See diagram 9.
Diagram 5
7)From the right side of the unit connect the black electrode wire to the DC Sparker as shown in diagram 6.
Diagram 6 | Electrode Wire |
8)Secure the loose wires into the wire clips above and to the bottom left of the DC Sparker as shown in diagram 7.
Diagram 9 | Grommet |
|
12)From the left side faceplate panel expose the fan wires from the sleeve and connect them to the wires from the unit as shown in diagram 10.
Diagram 10
18 | Regency® L234 Direct Vent Gas Insert |