INSTALLATION
OPTIONAL BACKING PLATE
INSTALLATION
Backing Plate Contents List:
9 | Screws (#8 x 1/2" Type B Black) |
1 | Backing Plate |
Backing Plate Assembly:
Customize Backing Plate:
The Backing Plate can be adjusted to custom fit an installation by trimming the inside of the top, corner and side pieces as shown in the diagram below. The dotted lines shown are only an example of where you can cut. Cuts can be made beyond these marks as required.
Trim the backing plate using a metal cutting blade. No cut edges will be exposed once installation is complete.
NOTE: In place of where any existing screw holes are cut, new holes will need to be drilled for attachment.
Backing Plate Installation:
Attach Top Backing Plate to Faceplate
1)Remove the faceplate (Contour or Contemporary) from the unit if already installed.
2)Lay the faceplate on its front, on a soft surface to prevent scratching.
3)Attach the top piece of the backing plate to the faceplate using 5 screws provided as shown in diagram 1.
Rear View of Faceplate
Diagram 1
Attach Faceplate & Top Backing Plate to Unit
4)Place the 4
The inside of the backing plate may be cut as required using a metal cutting blade.
Do not cut the outside edges.
Rear View of | Diagram 2 |
Backing Plate |
|
20 | Regency® L234 Direct Vent Gas Insert |