INSTALLATION
INSTALLATION
CONVERSION KIT #536-969 FROM NG TO LP
LP Conversion instructions for BEFORE UNIT INSTALLATION.
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER, IF IN DOUBT DO NOT DO THIS CONVERSION!!
LP Conversion Kit Contains:
Qty. | Part # | Description |
1 | LP Pilot Orifice | |
1 | Orifice #54 | |
1 | 5/32" Allen Key | |
1 | LP Conversion Decal | |
1 | Red Propane Label | |
1 | Instruction Sheet |
1)Open the left and right side faceplate panels.
2)Turn off the gas supply.
3)Remove the bottom louver by pulling out.
4)Remove the glass door.
a)Pull off the left side spring hook that holds the door in place. While holding the hook turn it upside down and place it into the middle opening on the top side mounting bracket. Repeat for right side.
Top Mounting Bracket
b)Swing the door out 45 degrees and lift up and out.
Burner Removed
8)Remove the burner tray by undoing the 4 screws.
Spring Hook
5)Remove the logs if installed.
6)Remove the brick panels if installed.
7)Remove the burner by undoing the 3
screws. | Burner Tray Removed |
14 | Regency® L234 Direct Vent Gas Insert |
