Regency P121RC, P131 Log Installation, 02-79, Push back side of the left end of the log up

INSTALLATION

LOG INSTALLATION

Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.

The gas log kit (Part # 360-930) contains the following pieces:

1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.

2)Place Log 02-79 on the front right side of the burner. Ensure that the notches on the far right side of the log fit into the grate posts. Push back side of the left end of the log up against the tab on the burner.

a)	02-79	Front Right Log	902-326
b)	02-80	Front Left Log	902-327
c)	02-81	Middle Right Log	902-328
d)	02-82	Middle Left Log	902-329
e)		Embers	902-154

02-79

Please note that there are 2 of each log. This log set is mirrored front and back.

02-8002-79

Push back side of the left end of the log up

against the tab on the burner.

Repeat step 2 on the opposite side of the burner.

02-79

02-79

02-82 02-81

The "02" reference numbers (i.e. 02-79) are

molded into the rear of each log.

The image below shows all of the logs in place.

				3) Place Log 02-80 on the front left side of the burner. Position
				the right end of the log in between the two tabs and the left
02-81	02-79	02-82	02-80	end of the log into the grate post.

02-80

Tab on Burner

Grate Post

02-80 02-82 02-79 02-81

24 Regency P121-1/P121LC-1/P121RC-1/P131-1 Zero Clearance Direct Vent Gas Fireplace