Operating (cont’d)
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLED WITH WATER AND AIR PURGED FROM ALL LINES.
A.This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner. Do NOT try to light the burner by hand.
B.BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
•Do not try to light any appliance.
•Do not touch any electric switch;
do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in the gas control but- tons. Never use tools. If the control buttons will not push in, don’t try to repair them, call a qualified ser- vice technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
OPERATING INSTRUCTIONS
VACATION |
|
|
A | B | C VERY |
WARM |
| HOT |
COOLER |
| HOTTER |
*
*
*
1.STOP! Read the safety information above on this label.
2.Set the ON/OFF switch on the control box to the “ON” position.
3.Set the thermostat to the lowest setting by first press-
ing the COOLER and HOTTER buttons together and holding for 1 second. Then press the COOLER button until the WARM indicator light appears.
4.Set the ON/OFF switch on the control box to the “OFF” position.
5.This appliance is equipped with a device which auto- matically lights the burner.
DO NOT TRY TO LIGHT THE BURNER BY HAND.
6. Wait five (5) minutes to | clear out any gas. |
If you then smell gas, | STOP! Follow “B” in |
the safety information above on this label. If you don’t smell gas, go to the next step.
7.Turn on all electrical power to the appliance.
8.Set the ON/OFF switch on the control box to the “ON” position.
9.Set the thermostat to desired setting by first pressing
the COOLER and HOTTER 
buttons together and holding for 1 second. Then press the HOTTER button 
.
10.WATER TEMPERATURE ADJUSTMENT 
is approximately 120˚F.
CAUTION: Hotter water increases the risk of scald injury. Consult the instruction manual before changing temperature.
11.If the appliance will not operate, follow the instruc- tions “TO TURN OFF GAS TO APPLIANCE” and call your technician or gas supplier.
WARNING: TURN OFF ALL ELECTRIC POWER BEFORE SERVICING
TO TURN OFF GAS TO APPLIANCE
1.Set thermostat to the lowest setting by first pressing
the COOLER
and HOTTER
buttons together and holding for 1 second. Then press the COOLER button 
until the WARM indicator light appears.
2.Set the ON/OFF switch on the control box to the “OFF” position.
3.Turn off all electric power to the appliance if service is to be performed.
23
