Typical Installation
INTAKE FOR
COMBUSTION
EXHAUST AIR
VENT TO
OUTDOORS
FLUE PRODUCTS
DISCHARGE PIPE
Vacuum Relief required by some codes
(refer to local codes)
AIR INTAKE PIPE
COLD WATER INLET
Some models are equipped with
circulating loop fittings.
HOT WATER OUTLET 
TEMPERED
WATER OUTLET
MIXING
VALVE
SHUTOFF VALVE
TEMPERATURE-
PRESSURE RELIEF
VALVE
*HOT (OUTLET) RECIRCULATING
LOOP CONNECTION CAN BE
INSTALLED WITHIN 360° RADIUS
DIRECTION
OF FLOW
CHECK VALVE
MARKED WITH
DIRECTION OF
FLOW ARROW
GAS
SUPPLY
7' POWER CORD (Factory supplied)
|
| DISCHARGE PIPE |
|
|
| ||
|
|
|
|
| |||
| (Do not cap or plug) | *COLD (RETURN) RECIRCULAT- | |||||
| PROVIDE A 6″ AIR GAP | ING LOOP CONNECTION MUST | |||||
| BETWEEN THE END OF | BE INSTALLED ONLY IN THE | |||||
| UPRIGHT POSITION | ||||||
| THE DISCHARGE PIPE | ||||||
|
|
| AND DRAIN |
|
|
| |
|
|
|
|
| DIRECTION | ||
|
|
|
|
| OF FLOW | ||
|
|
|
|
| HEAT TRAP | ||
|
|
|
|
| |||
*Certain models do not have these connection assemblies shipped with the water heater. They (Part #9001262) are available through the manufacturer. See “Repair Parts” section for ordering information.
This appliance has been design certified as complying with American National Standard/CSA Standard for water heaters and is considered suitable for:
Water (Potable) Heating: All models are “considered suitable for water (potable) heating.”
Water (Potable) Heating and Space Heating: Certain models are “considered suitable for water (potable) heating and space heating.” Refer to the model and rating plate of the water heater.
WARNING
When the system requires water at temperatures higher than required for other uses, the hot water system may require a means such as a mixing valve to be installed to temper the water at certain points of use. Some peo- ple are more likely to be permanently injured by hot water than others; these include the elderly, children, the infirm, or the physically/mentally handicapped. Before immersing yourself or anyone else in hot water, be sure to check the water temperature. WARNING: HOTTER WATER INCREASES THE RISK OF SCALD INJURY. (Also see “Temperature Regulation” section) Mixing valves are available at plumbing supply or hard- ware stores. Follow manufacturers instructions for installation of these valves.
WARNING
This water heater shall not be connected to any heating systems or component(s) previously used with a non- potable water heating appliance.
If this water heater is also used for space heating applica- tions, all piping and components connected to the water heater shall be suitable for use with potable water.
WARNING
Toxic chemicals such as used for treatment of boilers or
NOTE: To protect against untimely corrosion of hot and cold water fittings, it is strongly recommended that
6
