Repair Parts

2			3	Outlet Parts Only
2			3	75 Gallon Models
				and 50 Gallon
				65,000 Btu/Hr
			4		Models
			5
				6
			8		7
					7
			9	11
			10
	33
	32
			12
	31			13	14
30
	29
28			29		15
28					15
	27	21
26		21		16
26		20	19
		20

24	22		18
24
25	23				34
25	23
			17

Page 36

Image 36

Reliance Water Heaters 606, 11-03, 184333-001 instruction manual Repair Parts

Contents

Used by this Water Heater What to do if YOU Smell GAS General Safety Discharge PipeMust not be plugged or blocked General Safety cont’d DEATH, Serious Bodily INJURY, or Property DamageJURY, or Property Damage Rious Bodily INJURY, or Property Damage Table of Contents Preparing for the New Installation Introduction Typical Installation Some models are equipped with Circulating loop fittings Locating the New Water Heater Facts to Consider About the Location Locating the New Water Heater cont’d Facts to Consider About the Location cont’dCombustion Air and Exhaust Wire Fence Air for Ventilation for Appliances Located Confined Spaces18″ Installing the New Water Heater Water Piping Installing the New Water Heater cont’d Temperature-Pressure Relief Valve Wiring Filling the Water Heater Wiring Diagram Venting Venting cont’d ALL 40 and 50 Gallon 40,000 BTU/HR ModelsVenting Through AN Outside Wall ALL 75 Gallon Models and 50 Gallon 65,000 BTU/HR Models Installing the New Water Heater contd Venting System Example Installations for ALL ModelsVent piping can be installed as follows Minimum vent length for all models is 18 inches Precautions Cementing PVC, ABS or Cpvc Pipe and FittingsVent Pipe Separation Connecting Vent to Blower Typical installationVenting contd Venting Through a Roof Gas Piping Venting Through a Roof CONT’D GAS Piping with Flexible Connector GAS Piping with ALL Black Iron Pipe to GAS ControlSediment Trap Installation Checklist Before Operating the Water HeaterIts hookup? Model Rating Plate Operating Before the Water Heater will OperateOperation ALL Models Make sure gas and electric power are connected properly Operating cont’dCheck for Leaks Water Heating Ignition Sequence For Your Safety Read Before Operating Temperature Regulation Temperature Indicators Temperature Adjustment Buttons For Your Information Start Up ConditionsOperational Conditions For Your Information cont’d Operational Conditions cont’d Periodic Maintenance Burner CleaningVenting System Inspection Burner Inspection Periodic Maintenance cont’d Temperature-Pressure Relief Valve OperationHousekeeping Anode Rod Inspection Drain Valve Washer Replacement ServiceDraining Leakage Checkpoints Troubleshooting Thermostat and GAS Supply Check Troubleshooting cont’d Systems Check Not Enough HOT WaterCondensation Protection Repair Parts Repair Parts cont’d This is a Repair Parts LIST, not a Packing ListPart Part Number Description 40 Gal.† Repair Parts 50 Gal.† Page