Remington Power Tools M30016AW, M30016AS Kickback Safety Devices On This Saw, English

IMPORTANT SAFETY INFORMATION

10.Before starting chain saw, make sure chain is not touching anything.

11.To guard against electrical shock, avoid body contact with grounded objects such as pipes, fences, and metal posts.

12.Keep all parts of body away from chain when saw is running.

13.Do not force chain saw while cutting. Apply light pressure. It will do the job better and safer at the rate for which it was intended.

14.Cut small brush and saplings with extreme care. Slender material may catch in chain and be whipped toward you. This could also pull you off balance.

15.When cutting limb or tree trunk that is under tension, use extreme caution. Be alert for wood springing back. When wood tension is released, limb could spring back and strike operator causing severe injury or death.

16.Carry chain saw from one place to another

•with saw stopped and unplugged

•by holding front handle (never use hand guard as handle)

•with finger off trigger

•with guide bar and chain to rear

WARNING: This product contains chemicals known to the State of Cali- fornia to cause cancer or birth defects, or other reproductive harm.

WARNING: Some dust created by power sanding, sawing, grinding, drill- ing, and other construction activities contains chemicals known (to the state of California) to cause cancer, birth defects, or other reproductive harm. Some examples of these chemicals are:

•lead from lead-based paints

•crystalline silica from bricks and ce- ment and other masonry products

•arsenic and chromium from chemi- cally-treated lumber

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ven- tilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.

KICKBACK

WARNING: Kickback may occur when the nose or tip of the guide bar touches an object, or when the wood closes in and pinches the saw chain in the cut. Tip contact in some cases may cause a lightning fast reverse reaction, kicking the guide bar up and backtowardstheoperator.Pinchingthe saw chain along the top of the guide bar may push the guide bar rapidly back towards the operator. Either of these reactions may cause you to lose control of the saw which could result in serious injury to user.

Kickback Safety Devices On This Saw

This saw has a low-kickback chain and reduced kickback guide bar. Both items reduce the chance of kickback. Kickback can still occur with this saw.

Follow assembly instructions. Do not remove front hand guard. Do not replace front hand guard with substitute.

The following steps will reduce the risk of kick- back.

•Use both hands to grip saw while saw is running. Use firm grip. Thumbs and fingers must wrap around saw handles.

•Keep all safety items in place on saw. Make sure they work properly.

•Do not overreach or cut above shoulder height.

•Keep solid footing and balance at all times.

•Stand slightly to left side of saw. This keeps your body from being in direct line with chain.

Direction

Do Not Let

Guide Bar

Touch Here

90° Quadrant

Figure 1 - Kickback Hazard Example: Do Not Let Nose of Guide Bar Touch Object While Chain is Moving

ENGLISH

5 www.remingtonpowertools.com