Remington Power Tools M30016AW, M30016AS Assembly, English, Retighten the bar nut finger tight

ASSEMBLY

8.Pull the guide bar away from the saw body so that the guide bar is fully extended and the slack is removed from the chain. (See Figure 6)

Guide Bar

Adjusting

Hole

Figure 6 - Pulling Guide Bar

9.Insert the sprocket cover tab into the saw body tab slot, Step 1. Then lower sprocket cover onto guide bar bolt, Step 2 (See Figure 7). NOTE: At this point the sprocket cover will not be flush against the saw body.

10.Finger tighten the guide bar nut onto the guide bar bolt. (See Figure 8).

Guide

Bar Nut

Figure 8 - Guide Bar Bolt

11.Slowly slide guide bar into saw body until the adjustment block goes into the round adjusting hole on the guide bar. (See Figure 6) NOTE: This locks the guide bar in place. You should not be able to push or pull the guide bar.

12.Retighten the bar nut finger tight.

13.Adjust the saw chain tension. Follow the steps under Saw Chain Tension Adjustment..

ENGLISH

Tab Slot Sprocket Cover Tab

Sprocket Cover Tab

Figure 7 - Installing Sprocket Cover

11 www.remingtonpowertools.com