Using the VPAP Adapt SV
WARNING
! Before starting therapy with a new mask select the correct mask type in the Settings menu (page 22). When adding or removing a new component such as a mask, humidifier, or
Starting Treatment
When the system is fully assembled press the power switch at the back of the VPAP Adapt SV to ON. The Welcome screen will be displayed while the flow
generator is warming up. Allow the unit to warm up for approximately 30 seconds before placing the mask on your face.
WELCOME
Figure 11: Welcome screen
Once the VPAP Adapt SV has warmed up, breathing into the mask should start therapy immediately. If not, press the Start/Stop key once to commence treatment.
The VPAP Adapt SV restarts in the mode in which it stopped.
Stopping Treatment
If SmartStop is enabled treatment will stop automatically when you remove your mask. If the SmartStop function has been disabled, press the Start/Stop key.
Standby Mode
VPAP ADAPT SV menu
Figure 12: Standby screen
Once you have stopped treatment the VPAP Adapt SV will be in standby mode. In standby you can:
•press the power switch at the back to OFF to turn off the flow generator
•commence treatment again by breathing into the mask or pressing the Start/Stop key
•enter any of the menus by pressing the Left key.
When in standby mode, a gentle
Note: If the SMART DATA - AUTO APPEAR option is set to ON the screens available under the Results menu will be displayed automatically for approximately 20 minutes after your session is completed.
Using the VPAP Adapt SV | 17 |
