Problem | Possible Cause | Solution |
|
|
|
Display error message: | The air tubing is loose or |
Check tube!! | blocked. |
Key if done |
|
Check that the air tubing is connected securely to your mask and the air outlet on the front of the S8 AutoSet Spirit.
When you have checked the air tubing, press the Start/Stop key to restart the device.
If this does not clear the message, disconnect the power cord and then reconnect it to restart the device.
Display error message: Component failure. | Return your S8 AutoSet Spirit for |
SYSTEM ERROR | servicing. |
Call service! |
|
Display error message: | You have experienced | |
High | leak in | excessively high leak levels |
last | session | during the night. |
Check that your air tubing is connected properly and that your mask does not leak excessively. Use the
If this message appears again, contact your clinician.
Display error message: | You have experienced |
HIGH LEAK!!! | excessively high leak levels for |
Adjust Mask | more than 20 seconds. |
Check that your air tubing is connected properly and that your mask does not leak excessively. Use the
If this message appears again, contact your clinician.
Display error message: | Component failure. | Return your S8 AutoSet Spirit for |
Exxxx (where xxxx |
| servicing. |
defines an error) |
|
|
The following message is displayed on the LCD after you try to update settings using the Data Card:
Card Error
Remove Card
The Data Card is not inserted correctly.
The Data Card is only partly inserted.
Ensure that the Data Card is inserted with the arrow facing up and pointing towards the device. Ensure that the device is switched on and in standby mode before you insert the Data Card.
Ensure that the Data Card is inserted into the slot on the Data Card module as far as it will go.
TROUBLESHOOTING 33