5.Connect the S9 VPAP Tx to the Tx Link via USB serial cable.
6.Plug the other end of the power cord into the power outlet.
7.Connect one end of the air tubing firmly onto the air outlet.
8.Connect the assembled mask system to the free end of air tubing.
The S9 VPAP Tx does not use the SD Card function to store data. All necessary data is transferred via Tx Link and available through the EasyCare Tx software.
Notes:
•• Always ensure that the S9 VPAP Tx is placed in an area where the alarm LED indicators are clearly visible.
•• Place the power supply unit away from the H5i to allow for adequate ventilation.
Filling the water tub
WARNING
Beware of electrocution. Do not immerse the device, humidifier, power supply or power cord in water. In the event of a spill, disconnect the device from the power supply and let the parts dry. Always unplug the device before cleaning and make sure that all parts are dry before plugging in the device.
CAUTION
•• Do not overfill the water tub as water may enter the device and air tubing.
•• Do not use any additives (eg, scented oils and perfumes).These may reduce the humidification output of the H5i and/or cause deterioration of the water tub materials.
•• Take care when handling the H5i as the water/water tub may be hot. Allow 10 minutes for the heater plate and any excess water to cool.
•• If liquids are inadvertently spilled into or on the H5i, unplug the device from the power outlet. Disconnect the H5i from the device and allow it to drain and dry before
8
