ResMed S9 VPAP Tx manual Clinical setup menu parameters, Parameter Modes, Range Description, Ü ü

Clinical setup menu parameters*

Parameter

Modes

CPAP AutoSet VAuto S ST T PAC iVAPS ASV ASVAuto

Range

Description

Settings

Circuit

Mask type	ü ü ü ü ü ü ü ü ü ü	Full Face / Nasal	Selects the type of mask used
		/ Pillows / Nasal	by the patient.
		Ultra / Pediatric
		Default: Full Face
Tube type	ü ü ü ü ü ü ü ü ü ü	SlimLine /	Shows the type of air tubing
		Standard / 3 m	used by the patient.
		Default: Standard	Not displayed if ClimateLine or
			ClimateLineMAX is connected
AB filter	ü ü ü ü ü ü ü ü ü ü	No / Yes	Enables or disables antibacterial
		Default: No	filter.
			Not displayed if H5i is
			connected.
Ext.	ü ü ü ü ü ü ü ü ü ü	No / Yes	Enables or disables an external
humidifier		Default: No	humidifier.
Therapy
Mode	ü ü ü ü ü ü ü ü ü ü	CPAP / S / ST /	Sets the therapy mode available
		T / PAC / iVAPS /	on the device.
		ASVAuto / ASV /
		AustoSet / VAuto
		Default: CPAP
Set pressure	ü	4–20 cm H2O	Sets the fixed treatment
		Default:	pressure.
		4 cm H2O
EPR Level	ü ü	Off / 1 / 2 / 3	Sets the EPR value.
		Default: 3
Height	ü	44-100 inches	Body height needed for the
		(110–250 cm)	dead space determination.
		Default: 70 inches
		(175 cm)
Target Pt	ü	8–30 BPM	The rate input to the iVAPS
Rate		Default: 15 BPM	algorithm. This should be set at
			the patient’s actual respiratory
			rate.
Target Va	ü	1–30 L/min	Used to determine the amount
		Default: 5.2 L/min	of pressure support required by
			the iVAPS algorithm.
IPAP	ü ü ü ü	4–30 cm H2O	Sets the pressure which will be
		Default:	delivered to the patient when
			the device is triggered into
		10 cm H2O
			inspiration.
*Default settings may differ from country to country

16