INSTALLATION AND SYSTEM SET UP
SetUp: Free-Run Mode
18 SuperView3000 User Manual May9, 2002
4
FRONT PANEL ADJUSTMENT
Toadjust the host timing from the front panel, follow the steps below.
Step1 - Verify connections Toperform the interactive timi ng adjustment,
makesure the host computer is switched on and connected at the SuperView’s
BACKGROUND INPUT.
Step2 - Begin Interactive Timing Adjust (ITA) Press the OUTPUT button
andnavigate through the menu to the Output Timing Adjust option. Press
ENTERto begin the adjustment process—a white box and cross hair appear on
youroutput display.
Step3 - First adjustment Use the four directional arrow buttons to position
thetop leftcorner of the box at thetop left corner of the display monitor. Press
ENTERto save changes and move to the second part of ITA.
Step4 - Second adjustment Use the four directional arrow buttons to
position the botton right corner of the box at the bottom right corner of the
display monitor. Press ENTER to save changes.
Step5 - Repeat adjustment procedure Perform the adjustmentprocedure for
eachcorner twice. This repetition is necessary toaccurately fine-tune the timing
parameters.
Saving adjustment Onceyou have adjusted your host, you should save it to
thehost list. The next time you use the same host, the SuperView will recall
yoursaved s ettings and use them for the output timing. To save a host, navigate
throughthe Output menu un til you see the menu called Save Host.Youcan
press ENTER to save the host to one of the ten user-definable entries on the host
list. Note that from the front panel, the default host name will be used.
Onceyou have completed the ITA procedure, finish the set up of your unit by
addressingthe different window image controls available from the front panel
orthrough serial control. For front panel control, refer to Chapter 5 and for
serial control, refer to the Command Set in Chapter 6.
................................................
SET UP: FREE-RUN MODE
InFree-run mode, the SuperView generates sync internally.Only window input
sourcesare connected; there is no source at the BACKGROUND INPUT connector.
Toset up a SuperView for Free-run operation, you can followthe same steps
outlinedabove for the AutoSync mode. The only difference being that you do
notneed to have a host computer connected to the BACKGROUND INPUT
connector.
Note thatFree-run mode is the factory default mode of the SuperView.