MAINTENANCE

MAIN CV DRIVELINE SAFETY SHIELD

(FIGURE Mnt-R-0032)

To remove the outer CV cone, remove the locking screws from shield cone. Remove cone over yoke. MNT-R- 0038. Remove bearing ring and remove the locking screws from inner shield cone. Mnt-R-0038.Turn inner cone to assembly position and remove half shield. Remove bearing ring. MNT-R-0038.

MAINTENANCE

To assemble outer CV driveline, grease yoke groove and inner profile tube. Attach bearing ring on groove with recesses facing profile tube. Slide on half shield with cone. Turn cone until it engages correctly. Tighten locking screws. Grease bearing groove in double yoke. Insert bearing ring. Slide guard cone for double yoke over cam from the connecting end. Make sure holes for screws are visible. Tighten locking screws. MNT-R-0039

Important! Check that Guard Missing decal on steel tube under inner guard

and Rotating Driveline Decal are

firmly affixed, undamaged and readable. If not, replace.

TURBO 96 01/11

Maintenance Section 5-12

© 2011 Alamo Group Inc.

Page 174
Image 174
Rhino Mounts TURBO 96 manual Main CV Driveline Safety Shield, Figure Mnt-R-0032