
ASSEMBLY
HYDRAULIC OR MANUAL LIFT - PULL & OFFSET TYPE
Attach the Spring Assembly option (Figure
CASTER WHEEL ASSEMBLY (Semi-Mount)
Standard 4:00 x 8 caster wheel assembly
Install the two axle arm weldments (1) on the rear axle so that the Main Beam or tube of weldment is angled down toward ground. Space axle arm weldment (1) so wheels will be at the desired row spacing. Install all four bolts (3) in each axle arm weldments and tighten bolts evenly so that space between upper and lower clamp faces remain approximately the same. Figure
TURBO 96 01/11 | Assembly Section |
© 2011 Alamo Group Inc.