Rhino Mounts TURBO 96 manual Dealer SET-UP Instructions, Frame ASSEMBLY-LIFT Type

ASSEMBLY

ASSEMBLY

DEALER SET-UP INSTRUCTIONS

The mower as received from the factory is partially assembled and requires minimum time to complete assembly and is ready for sale.

The mower is shipped vertically with shipping brackets. These shipping brackets are intended for use in transporting the mower from the factory to dealer.

DO NOT use these brackets to store the unit. DO NOT store mower vertically, the mower can fall over resulting in serious injury or death. To avoid injury, always store mower lying down on flat ground.

Assembly will be easier if components are aligned and loosely assembled before tightening hardware. Refer to Bolt Torque Chart in Maintenance Section. All bolts are grade 5 unless otherwise specified.

A-FRAME ASSEMBLY-LIFT TYPE

1.Insert bushing (15) into lower end of each A-Frame half (1 & 2). Position each A-Frame half inside Main- frame Lug. Install bolt (19) with Flatwasher (20) through bushing (15) in A-Frame half (1 & 2) and hole in inside Mainframe lug. Install locknut (10).

2.Install bushing (6) between braces (3) through top rear hole of A-Frame and insert bolt (12), flatwasher

(20)and locknut (10). Install Driveline Holder Bracket (22) to left A-Frame (2) with bolt (17) and locknut

3.Install bushing (21) between A-Frame halves (1 & 2) and insert bolt (13) and locknut (14). Then attach braces (3) and brace (7) by installing bushings (15) through brace (7), and install bolt (9) and locknut (10) through braces (3) and brace (7). Then attach another bushing (5) in between braces (3) with bolt (9), and locknut (10).

4.Install brace support (7) to the rear lugs on the Mainframe with pivot pin (8) and retain with bolt (17) and locknut (10). FIGURE Asm-R-0282

TURBO 96 01/11 Assembly Section 3-2

© 2011 Alamo Group Inc.