Ricoh 106 Po w er Source:

CLASS 1 LASER PRODUCT

IN ACCORDANCE WITH IEC 825

LASER KLASSE 1 nach IEC 825

Introduction

This manual contains detailed instructions on the operation and maintenance of this machine. To get

maximum versatility from this machine, all operators should carefully read and follow the instructions in

this manual. Please keep this manual in a handy place near the machine.

Please read the safety information on pages i - iii of this manual. It contains Important Information related

to user safety and preventing equipment problems.

Operator Safety:

This machine is considered a class 1 laser device, safe for office/ EDP use. The machine contains a 5-

milliwat, 765 - 805 nanometer wavelength, GaAIAs laser diodes. Direct (or indirect reflected) eye contact

with the laser beam might cause serious eye damage. Safety precautions and interlock mechanisms have

been designed to prevent any possible laser beam exposure to the operator.

The following label is attached on the machine.

This label can be found when opening the bypass tray.

Laser Safety:

The optical housing unit can only be repaired in a factory or at a location with the requisite equipment. The

laser subsystem is replaceable in the field by a qualified Customer Engineer. The laser chassis is not

repairable in the field. Customer engineers are therefore directed to return all chassis and laser subsys-

tems to the factory or service depot when replacement of the optical subsystem is required.

Notes:

• Model names for the machines do not appear in the following pages. Check the type of your ma-

chine before reading this manual.

Bizworks 706

• Some illustrations may be slightly different from your machine.

• Certain types may not be available in some countries. For details, contact your local dealer.

Two kinds of size notation are employed in this manual. With this machine refer to the metric version.

For good print quality, Ricoh recommends that you use genuine Ricoh toner.

Ricoh shall not be responsible for any damage or expense that may result from the use of parts other than

genuine Ricoh parts in your Ricoh office product.

Power Source: 220 ~ 240 V, 50/60 Hz, 2.2 A

Please make sure to connect the power cord to a power source as above. For details about power con-

nection, refer to page 8.

Trademarks

Microsoft®, Windows®, and MS-DOS® are registered trademarks of Microsoft Corporation in the United

States and/or other countries.

Other product names used herein are for identification purposes only and might be trademarks of their

respective companies. We disclaim any and all rights in those marks.

In accordance IEC 60417 this machine uses the following symbols for the main switch:

ameans POWER ON.

bmeans POWER OFF.

“The Product complies with the requirements of the EMC Directive 89/336/EEC and the Low Voltage

Directive 73/23/EEC.”

Declaration of Conformity

706_GB_2~3 99.8.3, 1:07 PM1