Copying

Copying from Paper Tray 2

 

 

Use paper tray 2 for copying onto

 

 

special paper (OHP transparencies,

 

 

label paper (adhesive labels), thick

 

 

paper (postcards, envelopes, etc.),

 

 

thin paper as well as plain paper.

2

 

 

You can make special paper settings

 

 

 

 

at any time.

•You can use Paper Tray 2 as an al- ternative Bypass Tray when it is temporarily selected.

•You can also use Paper Tray 2 as an ordinary tray.

Note

❒ If you do not use standard size copy paper, you should input vertical and horizontal dimensions. The sizes that you can input are as follows.

Metric

• Vertical: 100.0 – 297.0 mm

version

• Horizontal: 148.0 – 432.0 mm

 

 

 

Inch

•

Vertical: 3.94" – 11.69"

version

•

Horizontal: 5.83" – 17.00"

 

 

 

❒ For sizes, types, and thicknesses of paper you can use, or the maximum number of sheets you can load at once, See "Copy Paper", General Settings Guide.

❒ To copy onto special paper such as OHP transparencies, thick paper (postcards, envelopes, etc.), thin paper, and adhesive label paper, you must specify the paper type. See p.29 “When copying onto special paper”.

❒ To load paper, See "Changing the Paper Size of the Paper Tray", General Settings Guide.

Using Tray 2 as the Bypass Tray

A Select tray 2, and then press the {#}key.

Important

❒Paper size and type settings

programmed by pressing the {#}key are cleared and reset au- tomatically when copying is completed.

❒If the paper size shown on the key for tray 2 is different that of the paper set in tray 2, paper might misfeed. Be sure to re- move any paper left in the tray after copying.

When copying onto standard size paper

This setting is necessary when temporarily copying onto a paper size not shown on the size key of tray 2.

Note

❒This setting is not necessary if the size displayed on the key for tray 2 and that of the paper set in tray 2 are the same.

❒You can also specify the size of paper directly, using the paper size selector for tray 2.

22