RIDGID JP06101 manual Assemble Fence To Bed, Install Cutter Head Guard, Assembly Fence Nut Mount

Assembly (continued)

Assemble Fence To Bed

1. From the hardware pack find the following:
1	Washer 1/2"
1	T-Nut
From among the loose parts find the following
1	Fence Assembly

Fence Lock Knob

T-Nut

Washer 1/2" (Actual Size Not

	1	Fence Lock Knob
	1	Fence Tilt Knob
2.	Position fence onto fence support as shown making
	sure the keyway in fence assembly lines up with the
	key on the fence mount.
3.	Once fence is in place, slide the fence lock knob
	through the 1/2" washer and then through the fence
	assembly and fence mount. Thread T-nut onto the end
	of the lock knob. Make sure the tabs on the nut sit in
	the slot on the fence mount.
4.	Slide the fence back and fourth to make sure it moves
	freely. Then lock in place.
5.	Thread the fence tilt knob into the fence.

(Actual Size Not Shown) Shown)

Fence Assembly

Fence Tilt Knob

Fence Lock

Knob

Fence	Washer
Assembly

Fence	T-Nut
Mount

Install Cutter Head Guard

1.From among the loose parts find the cutter head guard. Remove the pan head screw from the bottom of the guard post.

2.Turn the spring-loaded knob 1 turn counterclockwise, looking down through the hole in the infeed table.

3.Line the slot in the guard post with the pin in the knob. Slide the post through table and over pin in the knob.

4.Reinstall the pan head screw in the bottom of the guard post.

NOTE: The two ribs on top of the fence indicate where the cutter head opening is located in the table.

Cutter Head

Guard

Slot

Spring Loaded

Knob

Cutter Head

Opening Indicators

18