ASSEMBLY
UNPACKING
This product requires assembly. | WARNING: |
Carefully lift saw from the carton by the carrying handle and the saw base, and place it on a level work surface. NOTE: This tool is heavy. To avoid back injury, lift with your legs, not your back, and get help when needed.
This saw has been shipped with the saw arm secured in the down position. To release the saw arm, push down on the top of the saw arm, cut the
Lift the saw arm by the handle. Hand pressure should remain on the saw arm to prevent sudden rise upon release of the tie wrap and/or depth guide.
Inspect the tool carefully to make sure no breakage or damage occurred during shipping.
Do not discard the packing material until you have care- fully inspected and satisfactorily operated the tool.
The saw is factory set for accurate cutting. After assembling it, check for accuracy. If shipping has influenced the settings, refer to specific procedures ex- plained in this manual.
If any parts are damaged or missing, please call
WARNING:
If any parts are damaged or missing, do not oper- ate this tool until the missing parts are replaced. Failure to heed this warning could result in serious personal injury.
WARNING:
Do not attempt to modify this tool or create acces- sories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
Do not connect to power supply until assembly is complete. Failure to comply could result in acciden- tal starting and possible serious personal injury.
WARNING:
Do not start the miter saw without checking for interference between the saw blade and the sliding miter fences. Damage could result to the blade if it strikes the miter fence during operation of the saw.
WARNING:
Always make sure the compound miter saw is securely mounted to a workbench or an approved workstand. Failure to heed this warning can result in serious personal injury.
MOUNTING HOLES
See Figure 8.
The compound miter saw should be mounted to a firm supporting surface such as a workbench, mounting board, or leg stand. The saw base has eight mounting holes: four large bolt holes (B) and four small screw holes (A). If using bolts, they should be of sufficient length to accommodate the saw base, lock washers, hex nuts, and the thickness of the workbench or other mounting surface. Tighten all four bolts or screws securely. Do not use screws if mounting to a leg stand.
The hole pattern for mounting to a workbench is shown in figure 8. Carefully check the workbench after mounting to make sure that no movement can occur during use. If any tipping, sliding, or walking is noted, secure the workbench to the floor before operating.
TRACE HOLES AT THESE | B | A | A | B |
|
|
|
|
|
| |
LOCATIONS FOR HOLE PATTERN |
|
|
|
|
|
(A - SCREWS AND B - BOLTS) |
|
|
|
|
|
| A |
|
| A |
|
| B |
|
|
| |
|
|
| B |
| |
|
|
|
| MOUNTING |
|
| SAW BASE |
|
| SURFACE | Fig. 8 |
|
|
|
| ||
|
|
| 15 |
|
|
