MAINTENANCE
WARNING:
When servicing, use only identical replacement parts. Use of any other part may create a hazard or cause product damage.
BRUSH |
| BRUSH |
CAP | BRUSH | ASSEMBLY |
|
| |
| ASSEMBLY |
|
WARNING:
Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petro-
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. Therefore, no further lubrica- tion is required.
WARNING:
To ensure safety and reliability, all repairs should be performed by a qualified service technician at an authorized service center to avoid risk of personal injury.
Some areas will require infrequent lubrications. You will need to apply:
Automotive oil directly to the slide bars.
Light oil or a pressurized light spray oil to the arm pivot shaft.
Light oil or a pressurized light spray oil to the torsion spring.
BRUSH REPLACEMENT
See Figure 50.
The saw has externally accessible brush assemblies that should be periodically checked for wear.
Proceed as follows when replacement is required:
Unplug the saw.
BRUSH
CAP
Fig. 50
1/4 in.
BELT COVER
BELT
MOTOR MOUNT | BELT |
SCREWS |
|
ADJUSTING
SOCKET HEAD
SCREW
Fig. 51
36
